V series Vertical Shaft Impactor(V-810)

Vertical Shaft Impactor
CMC V series vertical shaft impactors (VSI), with perfect combinations of multi types anvils which form various crushing angles, changeable rotor speed, multi-crushing action by cascade feed ratio and hydraulic adjustable feed control gate, provides higher capacity and better product quality of fine material crushing. Thus the applications are wide, no matter aggregate shaping, crushed sand, minerals fine crushing and waste recycling and can reach uncompetitive effectiveness.


  • V-650
  • V-810
  • V-970


  • Especially suitable for fine material under 1/4 inch
  • Special discharge design can handle high percentage of mud and moisture
  • Unique high strength tungsten rotor tips increase service time up to150-430 hrs
  • Special anvils design with changeable crushing angle reaches higher crushing efficiency
  • Fully open cover for safe and maintenance
  • Single motor drive for reliable and efficient
  • Precise weight balance for stable operation with minimum vibration and fast installation to decrease foundation cost
  • Low operation noise and wear cost
  • Rapid and easy change of wear parts
  • High cubic class product with minimum flakiness ratio
  • Grease lubrication so without cooling system required


  • Construction Aggregates
  • Cement Industry
  • Steel Industry
  • Waste Recycling


    By following adjustments users can get best condition and gain best product quality, maximum capacity and minimum wear cost

  • Changeable rotor speed(1000-2500rpm)
  • Multi-types anvils
  • Adjustable multiple cascade feed ratio
  • Hydraulic adjustment feed control gate